基于点云三维重构的配合面装配间隙分析方法研究 |
Research on fitting clearance analysis method based on 3D reconstruction of point cloud |
|
HTML 查看全文 查看/发表评论 下载PDF阅读器 |
中文摘要: |
在大型航空复合材料零部件装配过程中难免出现装配对接间隙,由于间隙较小,当构件固定之后内部间隙不可达,难以测量。因此,为了克服这一难题,完成装配体小间隙的测量,本文提出了利用逆向重建和虚拟装配的方式进行装配间隙测量的方案。本文基于大型航空复合材料零部件测量的背景,结合双目视觉测量原理,采用视觉与激光相结合的测量方式,研究从点云获取至装配仿真模型的逆向重建技术,在CATIA的虚拟环境下完成装配间隙的测量。 |
英文摘要: |
In the process of assembly of large aviation composite parts, assembly clearance is inevitable, because the gap is small, when the component is fixed, the internal gap can not reach, so it is difficult to measure. Therefore, in order to overcome this problem, to complete the measurement of small gap in assembly, this paper proposes a method of assembly clearance measurement using reverse reconstruction and virtual assembly. Based on the background of the large aircraft composite parts measurement, combined with the principle of binocular vision measurement, this paper combines the measurement of vision and laser, studying the technology from point cloud obtained to the reconstruction of assembly simulation model, measuring the assembly gap by CATIA. |
|
中文关键词: 双目视觉测量 逆向重建 虚拟装配 |
英文关键词:binocular vision measurement reverse reconstruction virtual assembly |
基金项目: |
DOI:10.11823/j.issn.1674-5795.2017.03.03 |
引用本文:赵海洋,张洋,兰志广,李汝鹏,刘巍,邢宏文,肖睿恒,贾振元.基于点云三维重构的配合面装配间隙分析方法研究[J].计测技术,2017,37(3):20~23. |
关闭 |
|
|
|